Question

Drilling and milling machine active feeding device can complete the processing of different appearance, if the occurrence of defects will lead to the machine equipment can not be normal processing, then, when the drilling and milling machine active feeding equipment appears to be wrong, how should deal with it?

A view inside the gear box gear has no noise, if it is not now available before, then that is inside the gear of doubt, the demand down to see is a big gear, the gear is now can not be used, so if the situation needs to replace the gear.

Two, see the screw connection is not present doubt, this kind of situation, is good processing, will connect the local in this connection can, as long as can use, that is not feed, this situation is to say the problem of cohesion.

Three, check the drilling machine motor, gear box is connected to a small motor, if the small motor has doubt, directly contact the motor manufacturer, this look at the motor drilling speed, as well as the power status can be judged. If the above method is still unable to solve the problem of cutter, there may be a serious damage to the cutter, you can contact the milling machine manufacturers to send professionals to repair, perhaps replace the knife.